PX3511A, PX3511B
Description
PWM
1.18V<PWM<2.36V
0.76V<PWM<1.96V
t PDHU
t PDLU
t PDTS
t TSSHD
t PDTS
UGATE
LGATE
t PDLL
t FL
t RU
t RL
t FU
t TSSHD
t PDHL
FIGURE 1. TIMING DIAGRAM
Operation
Designed for versatility and speed, the PX3511A and
PX3511B MOSFET drivers control both high-side and low-
side N-Channel FETs of a half-bridge power train from one
externally provided PWM signal.
Prior to VCC exceeding its POR level, the Pre-POR
overvoltage protection function is activated during initial
startup; the upper gate (UGATE) is held low and the lower
gate (LGATE), controlled by the Pre-POR overvoltage
protection circuits, is connected to the PHASE. Once the
VCC voltage surpasses the VCC Rising Threshold (See
Electrical Specifications), the PWM signal takes control of
gate transitions. A rising edge on PWM initiates the turn-off
of the lower MOSFET (see Timing Diagram). After a short
propagation delay [t PDLL ], the lower gate begins to fall.
Typical fall times [t FL ] are provided in the Electrical
Specifications section. Adaptive shoot-through circuitry
monitors the LGATE voltage and determines the upper gate
delay time [t PDHU ]. This prevents both the lower and upper
MOSFETs from conducting simultaneously. Once this delay
period is complete, the upper gate drive begins to rise [t RU ]
and the upper MOSFET turns on.
A falling transition on PWM results in the turn-off of the upper
MOSFET and the turn-on of the lower MOSFET. A short
propagation delay [t PDLU ] is encountered before the upper
gate begins to fall [t FU ]. Again, the adaptive shoot-through
circuitry determines the lower gate delay time, t PDHL . The
PHASE voltage and the UGATE voltage are monitored, and
the lower gate is allowed to rise after PHASE drops below a
level or the voltage of UGATE to PHASE reaches a level
depending upon the current direction (See next section for
details). The lower gate then rises [t RL ], turning on the lower
MOSFET.
6
Adaptive Zero Shoot-Through Deadtime Control
These drivers incorporate an adaptive deadtime control
technique to minimize deadtime, resulting in high efficiency
from the reduced freewheeling time of the lower MOSFETs’
body-diode conduction, and to prevent the upper and lower
MOSFETs from conducting simultaneously. This is
accomplished by ensuring either rising gate turns on its
MOSFET with minimum and sufficient delay after the other
has turned off.
During turn-off of the lower MOSFET, the LGATE voltage is
monitored until it drops below 1.75V, at which time the
UGATE is released to rise after 20ns of propagation delay.
Once the PHASE is high, the adaptive shoot-through
circuitry monitors the PHASE and UGATE voltages during a
PWM falling edge and the subsequent UGATE turn-off. If
either the UGATE falls to less than 1.75V above the PHASE
or the PHASE falls to less than +0.8V, the LGATE is
released to turn on.
Three-State PWM Input
A unique feature of these drivers and other Intersil drivers is
the addition of a shutdown window to the PWM input. If the
PWM signal enters and remains within the shutdown window
for a set holdoff time, the driver outputs are disabled and
both MOSFET gates are pulled and held low. The shutdown
state is removed when the PWM signal moves outside the
shutdown window. Otherwise, the PWM rising and falling
thresholds outlined in the ELECTRICAL SPECIFICATIONS
determine when the lower and upper gates are enabled.
This feature helps prevent a negative transient on the output
voltage when the output is shut down, eliminating the
Schottky diode that is used in some systems for protecting
the load from reversed output voltage events.
In addition, more than 400mV hysteresis also incorporates
into the three-state shutdown window to eliminate PWM
FN6462.0
February 26, 2007
相关PDF资料
PXD303/050/01/1 POWER STRIP 10A 2M CORD 5OUTLETS
QW-4PLCC44 ADAPTER QUICKWRITER 4GANG 44PLCC
QW-4SO8/14N ADAPT QUICKWRTR 4GANG 8/14SOIC N
QW-4SO8/14W ADAPT QUICKWRTR 4GANG 8/14SOIC W
QW-4SOIC18 ADAPTER QUICKWRITER 4GANG 18SOIC
QW-4SOIC28 ADAPTER QUICKWRITER 4GANG 28SOIC
QW1 PROGRAMMER PIC MCU QUICKWRITER
R0K502M12S000BE BOARD FOR R8C/M12A
相关代理商/技术参数
PX3511BDDG-RA 功能描述:IC DRVR SYNC BUCK HF 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - MOSFET,电桥驱动器 - 外部开关 系列:- 标准包装:6,000 系列:*
PX3511D 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Advanced Synchronous Rectified Buck MOSFET Driver with Protection Features
PX3511DDDG-RA 功能描述:IC DRVR SYNC BUCK HF 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - MOSFET,电桥驱动器 - 外部开关 系列:- 标准包装:6,000 系列:*
PX3515BDDGR4XTMA1 制造商:Infineon Technologies AG 功能描述: 制造商:Infineon Technologies AG 功能描述:LV IC - Tape and Reel
PX3515BDDGR4XUMA1 制造商:Infineon Technologies AG 功能描述:LV IC - Tape and Reel
PX3516ADDG-R4 功能描述:功率驱动器IC Sync Rectified Buck MOSFET Driver IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
PX3516ADDGR4XTMA1 制造商:Infineon Technologies AG 功能描述:DC/DC IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC BUCK SYNC DRIVER DL TDSON10-2
PX3517FTMA1 制造商:Infineon Technologies AG 功能描述:LV IC - Tape and Reel